Graphing-point serial connection?

Question

Graphing-point serial connection?

Days good reading. Faced with the problem of drawing graphics according to the specified points.
There is an array of X,y, 10 records them on CHart need to draw a graph (example: img-host.org.ua/images/yryyryzwz.jpg ), but the result is the classic Chart.Series[].AddXY() does not match the desired result(example: img-host.org.ua/images/jpjjpj.jpg without Chart1.Series[0].XValues.Order:=loNone; ) (with Chart1.Series[0].XValues.Order:=loNone; img-host.org.ua/images/nhnnhn.jpg )

Toney.Schamberger94 asked July 9th 19 at 10:25

Related questions

More answers about "Graphing-point serial connection?"

2 answers

mercedes answered on · Accepted Answer · 2019-07-09T10:27:27.766Z

mercedes answered on July 9th 19 at 10:27

Solution

Both images are blank(I) full compliance.

Fixed the parser popped the bracket at the end of the link - Toney.Schamberger94 commented on July 9th 19 at 10:30

And the points are added in the correct sequence? - mercedes commented on July 9th 19 at 10:33

www.cyberforum.ru/delphi-multimedia/thread248201.html - mercedes commented on July 9th 19 at 10:36

: Yes, the dots in the right sequence. loNone tried, in the end ( img-host.org.ua/images/eoeeoe.jpg ) - Toney.Schamberger94 commented on July 9th 19 at 10:39

And for y and for x? - mercedes commented on July 9th 19 at 10:42

: Yes, Points on a smooth graph placed in the same sequence as on the broken Chart-e tried to swap the X, y, but the result remained almost the same, only mirrored. - Toney.Schamberger94 commented on July 9th 19 at 10:45

: img-host.org.ua/images/eoeeoe.jpg
The point is clearly not in the sequence. - Humberto_Lynch68 commented on July 9th 19 at 10:48

: : Fixed the screenshots in the post - Toney.Schamberger94 commented on July 9th 19 at 10:51

: : Thank you very much for your help. The problem was in the error of recalculation of these points, they took off values. Included in Chart1.Series[0].XValues.Order:=loNone; everything is drawn as it should - Toney.Schamberger94 commented on July 9th 19 at 10:54

: congratulations. - mercedes commented on July 9th 19 at 10:57

Humberto_Lynch68 answered on · Accepted Answer · 2019-07-09T10:29:27.767Z

Whether you need another type of number, whether a different setting range. Wait, experiment.

UPD. Two options.
1. A number Line to establish General→Options→Sort in None (aka XValues.Order=loNone), this will allow you to draw any squiggles.
2. To use a different type of series, Horizontal Line.

UPD2. The number of Fast Line too, there are opportunities.