Amplifier cellular (primarily 3G) with access to Ethernet — what to choose?

A country house, a cell tower in direct line of sight to 4km, 3G signal is very decent.
I want to hang a antenna amplifier + modem with Ethernet output, or set all-in-one. Looking toward Mikrotik RouterBOARD SXT LTE (RBSXTLTE3-7), but is in stock or not, or a premium of +100%.

Recommend a worthy counterparts?
July 9th 19 at 13:21
3 answers
July 9th 19 at 13:23
Solution
from sxt lte antenna 9dbi only, and it does not work with 3g.
there are two options: 1) cheap, not the fact that stable, a little collective; 2) such a decent price, concrete (unless mobilisimo to the transport network will not have problems), normally it looks quite compact.
option "2)" I was wondering, what do you recommend specifically? - jerry.Kerluke commented on July 9th 19 at 13:26
: antex-e unibox or rf elements stationbox xl cc rb912uag, huawei me909-521u, a set of pigtails, all this pitaetsa at the PoE. the output internetiki for normal twisted-pair (ethernet). you can put wi-fi access point if you want. it is important asmontaite this is all fine and configure as needed. - wilber_Moscis commented on July 9th 19 at 13:29
: Paraphrasing for understanding: 1) Antex-e unibox is just about the sealed box with passive antennas for outdoor USB 3G/4G whistle, whistle goes via USB in the house. 2) Rf elements stationbox xl cc is a box for outside installation Mikrotik Routerboards, respectively - in a box Mikrotik rb912uag in Mikrotik - mini-pcie cost huawei me909-521u? And Mikrotik out of the box huawei me909-521u sees? Or will need to come up with something? - jerry.Kerluke commented on July 9th 19 at 13:32
: 1) no, antenna+thermobox, where you can rasedate equipment and loss of signal almost will not be, there it is possible to install a very wide range of equipment; 2) Yes; the modem it is necessary to alter and prepare for work in Russia. - wilber_Moscis commented on July 9th 19 at 13:35
: Uh.. but rf elements stationbox xl cc - only 5GHz or 2.4 GHz options (Wi-Fi, in fact)? 3G from different operators of the Russian Federation from 1.9 to 2.2 GHz (relatively speaking)? - jerry.Kerluke commented on July 9th 19 at 13:38
in those areas where umts2100 works without straining. in the event 1800 - unibox - wilber_Moscis commented on July 9th 19 at 13:41
: Got it, thanks! - jerry.Kerluke commented on July 9th 19 at 13:44
: I highly recommend that you take it "integrated" solutions when the antenna is not connected to separate cable assemblies, and seems to be built in the General case. burned-out equipment with a missing ground in the circuit with a separate external antenna I have personally seen piles. - wilber_Moscis commented on July 9th 19 at 13:47
July 9th 19 at 13:25
A normal penny whistle from MegaFon/Beeline/MTS altered in HiLink + antenna. Or you essentially have ethernet and wifi in the house? If so then any normal cheapest mikrotik with usb port (type 951 model), and installed package lte. Mikrotik will pick up the modem and will get you into the net to give the Internet. I have so returny channel is organized, with external antennas to 30мбит squeezes.
You can certainly overpay for the SXT but why? The same functions and ports less.
A turnkey solution - a single point of failure. And here - still have to understand that welled - active antenna, whistle or USB port on the Mikrotik. And whistle to solder wires from the external antenna... Again, then there is the choice of antenna and whistle :) - jerry.Kerluke commented on July 9th 19 at 13:28
: I'll tell you a secret that sxt lte is mpci-ex modem on a normal Board, but all strongly compressed in size and does not leak (water would numb and rot all) - wilber_Moscis commented on July 9th 19 at 13:31
July 9th 19 at 13:27
It is necessary to divide the task into 2:
1. The signal booster for phones
2. Distribution of Internet get 3G.

If we consider the second task, then there are 2 options:
1. Cheap and cerita - RB951Ui-2HnD + USB modem (E3276 for example).
Custom, put in the window.
2. For difficult reception conditions BaseBOX2 (RB912UAG-2HPnD-OUT) + huawei ME909U-521 + directional antenna (or two)
And which antennas thus are recommending for the first task (amplification)? - jerry.Kerluke commented on July 9th 19 at 13:30
Depends on the frequency on which you are running 3G and the number of channels in the modem.
Anteks Nitsa-5 MIMO 2x2 (broadband)
Satellite dish 0,9 + irradiator Anteks AX-2000 OFFSET MIMO 2x2 - wilber_Moscis commented on July 9th 19 at 13:33

Find more questions by tags MikrotikMobile communication