Mikrotik metarouter how to add vlan?

Is mikrotik CRS109-8G-1S-2HnD. Used as a switch with vlan support and wifi point. It all LAN ports combined into a bridge. In port ether7 connected backup Internet channel, the port configured for vlan10. Ports ether2 and ether3 are trankovye, come and traffic from vlan10 and traffic without vlan-s (vlan1).
I added to metarouter openwrt image, created two dynamic interface vif1 and vif2. Now they are both connected in a bridge on the host, both receive address, the network is working. How to add one of these interfaces on vlan10?
I look through winbox, section switch->vlan. On the VLAN tab in my vlan10 can only add physical interfaces to a vif* interfaces are not there. And accordingly all the rules Eg. VLAN and In. VLAN you can only add the real interfaces.

I tried in the settings of the openwrt /etc/config/network to rename one of the interfaces eth1.10, but the interface just stops working (it appears in ifconfig, but the address on dhcp does not receive).

How to add a virtual interface metarouter-a in vlan10?
July 9th 19 at 13:42
More answers about "Mikrotik metarouter how to add vlan?"
1 answer
July 9th 19 at 13:44
you will most likely need to come from the back. really microtime to create a sub-interface and to forward it to dev.
In Mikrotik these interfaces is, vif1 and vif2. Only in the VLAN to add them, he does not. - gus.Wintheiser commented on July 9th 19 at 13:47
: it became interesting. plz give a link to the image, which is poured - Robyn commented on July 9th 19 at 13:50
I think the way to do with it, the interface in Mikrotik (host) does not add. But a way out of here https://habrahabr.ru/post/249541/ - gus.Wintheiser commented on July 9th 19 at 13:53

Find more questions by tags MikrotikNetwork administration