Mikrotik VPN = WAN + YOTA?

people tell me how to configure clients to mikrotika went to the Internet via yota..
and mikrotik as client connected to vpn (l2tp) server, but only through the wire through ether1 ?

-
in dhcp client yota 1 priority ether1 priority 2
August 19th 19 at 23:03
1 answer
August 19th 19 at 23:05
Depends on network configuration:
If it is possible to allocate a subnet to the VPN (for example it uses the network 10.10.0.0 and 192.168.1.0 LAN), the IP Route create rule, "on those IP this gateway". Well, everything else is determined by the rules ibid. IP VPN-server -> gateway "Eth1"
I do not understand :? I have the incoming Internet wire via 1 port dhcp client (the value to say 2, though there is static but it is then we understand), then raise the interface via yota and make it a dhcp client priority (say 1), here's how to dig....

to vpn understood only via ether1, and customers are sitting only through Yota (using yota let's change the gateway in the settings of the dchp server) - Fern.Pacoch commented on August 19th 19 at 23:08
to raise the VPN requires a VPN server that has a static IP., To the VPN connection is raised through a particular interface, hard enough to create a static route:
Destination IP address of VPN servera -> out interface - required interface.
so the rule "all packets to that IP to send through this interface". Well and further routing to resolve, as needed. - Josephine_Legr commented on August 19th 19 at 23:11

Find more questions by tags Mikrotik