How to make channel 2-level routing between the two ports?

Between multiple Cisco 7606 (c7600rsp72043-advipservicesk9-mz.122-33.SRE5.bin) do channels like this:

interface GigabitEthernet1/2.350<br> description ...<br> encapsulation dot1Q 350<br> xconnect 10.0.1.1 350 encapsulation mpls<br> mtu 1500<br> end<br>
But within the same router
%Local switching to peer address is not supported

Are there any known methods?
October 8th 19 at 00:09
2 answers
October 8th 19 at 00:11
Make them switched (Switchport) and create a Vlan, optionally, different tags to add vlan mapping
Functionality Sub-Interfaces of this are not lost
In General, Yes, but the same xconnect's on VLAN interfaces does not work. Prescribed, but do not work. Then you need all the routers to translate the polls to switch EN masse, and the scale of the provider is the problem yet. - Georgette_Goyette commented on October 8th 19 at 00:14
Well, there's certainly still a crutch in the form of a BVI (Bridge group)
But I'm not sure that this functionality is supported in hardware, because it is emulate swiching.

You can also try to raise the ip vrf and do xconnect between VRFами, but again, not sure this'll work.
And as for the Svi — Yes, some limitations are still there, but IMHO this is the right way, and don't forget that one side of the trunk VLAN to another can be subinterface - Jaycee_Kohler commented on October 8th 19 at 00:17
October 8th 19 at 00:13
Layer 2 Local Switching:
connect connection-name {interface} {interface}

Find more questions by tags Cisco