How to transfer VLAN management on the Cisco switch

By default on cisco switches Vlan1 is set as management vlan.
How to give control of the switch to another vlan and vlan1 is the right pick.

On the Internet googled about the team "management" but on my switch it is not.
October 8th 19 at 00:50
1 answer
October 8th 19 at 00:52
Solution
On "small" switches (like 2900 series), management vlan is the one vlan that has an ip address, so as default we have vlan1, You need to cut out and add the ip to another vlan, for example,

int vlan 99
ip add xxx.xxx.xxx.xxx 255.255.255.0
no shutdown

after disabling vlan1.
Management vlan can be only one!
For good, You would have to change the native vlan then - Dorothy_Smi commented on October 8th 19 at 00:55
What kind of heresy? You can go to switch to any address on any interface, if it is allowed in the ACL. - simeon_Fay commented on October 8th 19 at 00:58
2 shadowalone:
The fact of the matter is that in the 2950, for example, you cannot create more than one active interface vlan xxx ip address. By default, these switches, the interface is created in a state of shutdown. If he has to do a no shutdown, then active the other will go down.

Maxim_ka, here's a solution:
conf t

macro name ChVLAN
interface Vlan1
no ip address
shutdown

interface vlan100
ip address 1.2.3.4 255.255.255.0
no shutdown
@
!
macro global description ChVLAN

to run the macro:
macro global apply ChVLAN - Nedra_Hoppe commented on October 8th 19 at 01:01
Thank you of course, but the solution was not me, and I was just answering his question. - Dorothy_Smi commented on October 8th 19 at 01:04
the tag is not eaten... Buton wanted to write - Dorothy_Smi commented on October 8th 19 at 01:07

Find more questions by tags Network administrationCisco