Block pitana laptop gives loud popping noise, the periodicity is different, maybe once a minute, once in 10 minutes. Only when the laptop is off?

Clicks rather loud pop only if the laptop is switched off or the plug from the laptop to pull . Ie does not give your energy technology . When the laptop is on then everything is normal . But it is necessary to turn it off or pull the plug then a minute later hear the cotton . Getting a little creepy because of chlapci such that it seems right now, the block will break from the pressure
March 19th 20 at 08:32
1 answer
March 19th 20 at 08:34
Off and never never turn. Moreover, don't plug it to the laptop if the laptop you at least a little roads.

Give the PSU in for repair or buy a new one if can't parse, view (revision to do) and repair. Be very careful if you decide to take a "universal" PSU.

What kind of answer do you want? "never mind, that every second"? "in BP gremlins attract the user's attention by shots from a small cannon"?
They are often not portable, these BP - Maximo.Brown61 commented on March 19th 20 at 08:37
@Maximo.Brown61, rather, almost always. But that's not the problem, light strikes on the knife inserted into the joint and voila. To deal with that even people who never did before. - Braxton.Ro commented on March 19th 20 at 08:40
@Braxton.Ro, I had to write back "do not trade" )) Then often only duct tape. - Maximo.Brown61 commented on March 19th 20 at 08:43
By the way XS as specific to the laptop - I have a BP with a fork together - and I would have to disassemble it I didn't without experience - Suva rewound the plug into a 220 - well this - Maximo.Brown61 commented on March 19th 20 at 08:46
@Maximo.Brown61, Oh, Oh right. Adhesives chtoli little industry produces?

Suva rewound the plug into a 220 - well this

What?!
Most often, the problems are not just in the high part. Therefore, there is nothing to rewind will not. - Braxton.Ro commented on March 19th 20 at 08:49
@Braxton.Ro, see ) my BP combined with the plug directly without a cable. Opening the PSU - open the plug. The conductors from plug 99% that go directly into the cost - no cable (don't know how to call such an installation - I think it is clear - dull metal from the ends of the plugs directly to the Board) - based on the dimensions. Plus probably filled for the kiss these goodbye. Accordingly, the opening got a chance to damage. Clearly that is not going to explode (relatively), but the minimum can be damaged and start to warm up. And this is disappointing.

With BP which is on both sides of the wire a little easier - everything we have seen do not have housings 220-volt cable, itango in case - opening the case is extremely difficult even just to sway the nest.

So, TC-I note - it is better not to Suva where is flows 220 if the hands are not the most direct. - Maximo.Brown61 commented on March 19th 20 at 08:52
@Maximo.Brown61, so you got "cover" from the side (or both sides), in such BP seam off center, so you should not worry :)

The author is generally better not to meddle, if the "shots" in BP it strained just now, I will assume that there were already pieces five minimum. - Braxton.Ro commented on March 19th 20 at 08:55

Find more questions by tags Power supply unit