Sketch a floor of the pixel. Has anyone resolved the issue reasonably?

Tired already, got to the edge!
Draw for example a line or a border 2 pixels - these will take off 0.5 on each side

Has anyone found a solution?
And prompt?)
June 10th 19 at 16:19
2 answers
June 10th 19 at 16:21

1. Turn on “Pixel fitting”
This makes sure that the edges of your new layers always end up on full pixels. Same for when you move layers around.

June 10th 19 at 16:23
When I draw a line in 1рх, it should be with the coordinates ",5". Vector line itself follows the middle of the pixel, it frames the pixel line 0.5 px thick, which comes from the middle of the vector lines If the feature line will be on the pixel grid, leaving the center of the outline will go to half a pixel in the pixel grid, creating a soap line

Probably not too clearly explained, but I tried).
try to draw a line thickness of 2 pixels. I think the question was this. - Kiel_Rogahn37 commented on June 10th 19 at 16:26

Find more questions by tags Sketch