What is the mechanism which pushes?

Good day!
The task is to click on a few gopro cameras simultaneously.
It is possible for the timer-based take charge frm01 02 03 which would give a signal to all of the mechanisms which, in turn, pressed the camera record button.
How is naimatullah mechanism? Little is? The Chinese? We?

Thank you
June 14th 19 at 18:05
1 answer
June 14th 19 at 18:07
If it is necessary to click mechanically, then fit a solenoid or a servo.
If it is necessary to electrically close the switch, optorele/optocoupler.
If you have a GoPro they can be controlled remotely, there is a ready module for arduino esp8266 on the basis of
Thank you! They don't need the second option.
The third not suitable, as there is either wifi (eats battery) or you can disassemble the camera and solder. But this method is not suitable.

I look at optorele/optocoupler in Google and there ralescu, and where the mechanism which slides?

I'm not an electronics engineer , nothing in the hands not kept from this area .... I'm sorry if blunt - Saige.Bay commented on June 14th 19 at 18:10
that you messed up
optorele/optocoupler is to solder
you should see the solenoid/servile - there moves forward

isliker-gms_src_1.jpg - Kiley33 commented on June 14th 19 at 18:13
and I have to disappoint you, wifi will be more economical than a few solenoids. Any mechanical action is costly for the battery. ESP not so much eating - Kiley33 commented on June 14th 19 at 18:16
Yes, your example is a huge design that shoots straight.
I need to square 3-10mm weighed 3mm. Then I will remove this mechanism. - Saige.Bay commented on June 14th 19 at 18:19
there are small solenoids (you can control the speed and force of pressing), and use the ESP do not suffer - Kiley33 commented on June 14th 19 at 18:22
What is ESP ?
there is in the car protivosudorojna system.
I would like these dimensions mechanism with an electric circuit to find.
Current can be a lot of this procedure is to allocate, but not on camera. - Saige.Bay commented on June 14th 19 at 18:25
I'm afraid that this will be a problem.
And so you need esp8266 or esp32. There is a ready demo with a web interface. To supply enough conventional powerbank. It is advisable to take the finished boards, like nodemcu.
Be sure to check that your gopro can wifi, and then suddenly there the old model.

The best part is that you have enough base boards with a single click, just pour the finished firmware.

Better tell us what, maybe there are better ways - Kiley33 commented on June 14th 19 at 18:28
Yes thanks, but that wifi.
for gopro has remote control over wifi.
I have no wifi.
Thanks for the proposed options. - Saige.Bay commented on June 14th 19 at 18:31
than you are confused by Wi-Fi? - Kiley33 commented on June 14th 19 at 18:34

Find more questions by tags Arduinomechanic